Workshop of Advances in Analogue Circuit Design

Analog Circuit Design: Volt Electronics; Mixed-Mode Systems; Low-Noise and RF Power Amplifiers for Telecommunication Workshop of Advances in Analogue Circuit Design 1999 edition

Marc Notes: This book contains the revised contributions of 18 tutorial speakers at the seventh AACD '98 in Copenhagen, April 28-30, 1998--Pref.; Includes bibliographical references. Table of Contents: Preface. Part I: 1-Volt Electronics. Dynamic Translinear Circuits; W. A. Serdijn, et al. 1-V Log-Domain Filters; C. Enz, M. Punzenberger. 1V Switched-Capacitor Filters; A. Baschirotto, R. Castello. 1V DeltaSigma A/D Converters; V. Peluso, et al. 1-Volt RF Circuit Design for Pagers; E. Callaway. DC/DC Conversion, the Key to Low Power Consumption; E. C. Dijkmans, F. J. Sluijs. Part II: Design and Implementation of Mixed Modes Systems. Substrate Bounce in Mixed-Mode CMOS ICs; B. Nauta, G. Hoogzaad. Technology Impacts on Substrate Noise; F. J. R. Clement. Design Techniques to Reduce Substrate Noise; T. Blalack. 1.2 Gb/s CML Transceiver with 1M CMOS ATM/SDH Processor in a BICMOS Monochip; L. Dugoujon. Modeling Noise Coupling in Mixed-Signal/RF ICs; N. K. Verghese. Top-Down Design of Mixed-Mode Systems: Challenges and Solutions; G. G. E. Gielen. Part III: Low-Noise and RF Power Amplifier for the Communication. The Design of Narrowband CMOS RF Low-Noise Amplifiers; T. H. Lee. Design of Broadband Low-Noise Amplifiers in Deep-Submicron CMOS Technologies; J. Janssens, M. Steyaert. Put Your Power into SOA LNAs! P. Baltus. Radio Transceiver Circuits in Silicon Germanium; J. Sevenhans, B. Verstraeten. Modeling for Si-Bipolar Power Amplifiers; S. Weber. Design Considerations for GaAs MESFET RF Power Amplifiers; S. Taylor."Publisher Marketing: This volume concentrates on three topics: volt electronics, design and implementation of mixed-mode systems, and low-noise and RF power amplifiers for telecommunication. The book comprises six papers on each topic written by specialists. These papers are tutorial in nature and together aim to make a substantial contribution to improving the design of analog circuits. The book is divided into three parts. Part I covers volt electronics, presenting some of the circuit design challenges which are having to be met as the need for more electronics on a chip forces smaller transistor dimensions, and thus lower breakdown voltages. The papers cover techniques for 1-Volt electronics.

Contributor Bio:  Huijsing, Johan H Huijsing, Delft University of Technology, The Netherland. Contributor Bio:  Sansen, Willy M C Sansen, Katholieke Universiteit Leuven, Heverlee, Belgium. Contributor Bio:  Van de Plassche, Rudy J van de Plassche, Radio and Data Transmission Systems, Philips Research, Eindhoven, The Netherlands.